Video/RGB |
| Switcher | 8x4(x5) matrix video-follow-sync switching, adjustable blanking, sync detection, sync regeneration, front panel selectable sync input termination |
| Signal Types | RGB, composite, S-Video, and component video (does not transcode) |
| Formats | RGBHV, RGBS, RGsB, YUV, NTSC, PAL, HD up to 1080i/1080p |
| Horizontal Frequency | 10 to 200 kHz |
| Vertical Frequency | 20 to 200 Hz |
| Gain | 0dB (75 ohms terminated) |
| Bandwidth | 800 MHz (-3dB) |
| Blanking Time | Adjustable 0 to 10 seconds, 0.5 second steps |
| Sync Rise/Fall Time | 2 ns maximum |
Audio |
| Switcher | 8x4 stereo matrix switching; adjustable blanking; audio breakaway; input gain compensation; 4-channel stereo DSP w/5-band graphic EQ, volume, bass, treble, and mute control; paging mode (signal at Input 8 momentarily mixes with or overrides the current selected input at every output w/adjustable sensitivity and ducking behavior) |
| Signal Types | balanced and unbalanced stereo analog line-level |
| Typical of 8 stereo inputs: |
| Analog-To-Digital Conversion | 24-bit 48 kHz |
| Input Compensation | ±10.0 dB per input |
| Input 8 only, Paging Mode: |
| Mix Input Level | 0 to 100% |
| Sensing Threshold | -80 to 0 dB |
| Sensing Attack Time | 1 to 250 ms |
| Sensing Hold Time | 1 to 2000 ms |
| Ducking Depth | 0 to 80 dB attenuation |
| Ducking Release Time | 1 to 1000 ms per dB of recovery |
| Typical of 4 stereo outputs: |
| Digital-To-Analog Conversion | 24-bit 48 kHz |
| Frequency Response | 20 Hz to 20 kHz ±0.5 dB |
| THD + Noise | 0.005% |
| S/N Ratio | >104dB @ full output, A-weighted |
| Stereo Separation | >104dB |
| Output Channel Separation | >100dB |
| Blanking Time | Adjustable 0 to 10 seconds, 0.5 second steps |
| Output Volume Level Control | -80.0 to +20.0 dB, adjustable from 0% to 100% plus mute |
| Bass Control | ±15.0 dB |
| Treble Control | ±15.0 dB |
| EQ Mode | 5-band graphic EQ |
| GEQ Center Frequencies | 63, 200, 550, 2k, 12k Hz |
| GEQ Gain | ±12.0 dB per band |
Communications |
| Ethernet | For control and console, 10/100 Mbps, auto-switching, auto-negotiating, auto-discovery, full/half duplex, DHCP |
| Cresnet® | For control and console, Cresnet slave |
| USB | USB client for computer console |
Connectors – Video |
| IN 1 – 8 | (8) sets of (5) BNC female; |
RGB, component, S-Video, or composite video inputs; |
Formats: RGBHV, RGBS, RGsB, YUV, YPbPr, Y/C, NTSC, PAL; |
RGB Input Level: 1 Vp-p with ±0.5 VDC offset maximum; |
RGB Input Impedance: 75 Ohms nominal; |
Sync Input Types: RGBHV, RGBS[1], RGsB[1], YPbPr[1]; |
Sync Input Level: 3 to 5 Vp-p; |
Sync Input Impedance: 75 or 510 Ohms, independently selectable for H and V per input; |
Sync Detection: Reports discrete H and V signal presence and sync rates per input |
| OUT 1 – 4 | (4) sets of (5) BNC female; |
RGB, component, S-Video, or composite video outputs; |
Formats: Same as selected input; |
RGB Output Level: Same as selected input; |
RGB Output Impedance: 75 Ohms nominal; |
Sync Output Type: Same as selected input; |
Sync Output Level: 5 Vp-p |
Connectors – Audio |
| INPUT 1 – 8 | (8) 5-pin 3.5mm detachable terminal blocks; |
Balanced/unbalanced stereo line-level inputs; |
Maximum Input Level: 4 Vrms balanced, 2 Vrms unbalanced; |
Input Impedance: 24k Ohms balanced, 12k Ohms unbalanced; |
Note: Input #8 may be configured for “Paging” mode |
| OUTPUT 1 – 4 | (4) 5-pin 3.5mm detachable terminal blocks; |
Balanced/unbalanced stereo line-level outputs; |
Maximum Output Level: 4 Vrms balanced, 2 Vrms unbalanced; |
Output Impedance: 200 Ohms balanced, 100 Ohms unbalanced |
Connectors – Control & Power |
| LAN | (1) 8-wire RJ45 female; |
10Base-T/100Base-TX Ethernet port |
| NET | (1) 4-pin 3.5mm detachable terminal block; |
Cresnet slave port, connects to Cresnet control network; |
Does not draw power from the network |
| G | (1) 6-32 screw, chassis ground lug |
| 100-240V~50/60Hz 1A MAX | (1) IEC 60320 C14 main power inlet; |
Mates with removable power cord (included) |
| COMPUTER (front) | (1) USB Type B female; |
USB computer console port (6 ft cable included) |
LCD Display |
| Green LCD alphanumeric, adjustable backlight, 2 lines x 20 characters per line; |
Displays inputs/outputs by name, scan rates, audio settings, IP configuration and setup menus |
Controls & Indicators |
| SOFTKEYS | (4) pushbuttons for execution of LCD driven functions |
| HW-R | (1) recessed miniature pushbutton for hardware reset, reboots the switcher |
| CLEAR | (1) pushbutton and red LED, clears all matrix routing |
| VIEW | (1) pushbutton and red LED, toggles VIEW mode on/off |
| TAKE | (1) pushbutton and red LED, executes routing |
| MENU | (1) pushbutton, steps menu back one level |
| ENTER | (1) pushbutton, executes highlighted menu or value |
| A | (1) pushbutton & red LED, selects audio routing view |
| V | (1) pushbutton & red LED, selects video routing view |
| SYNC | (1) pushbutton & red LED, displays input sync rate |
| Quick-Adjust Knob | (1) continuous turn rotary encoder, adjusts menu parameters |
| IN 1 – 8 | (8) pushbuttons and red LEDs, select input to be routed |
| OUT 1 – 4 | (4) pushbuttons and red LEDs, select output destination(s) |
| LAN (rear) | (1) green and (1) amber LEDs, green indicates Ethernet link status, amber indicates Ethernet activity |
Power Requirements |
| Main Power | 1 Amp maximum @ 100-240 Volts AC, 50/60 Hz |
| Power Consumption | 30 Watts maximum |
| Cresnet Power Usage | none |
Environmental |
| Temperature | 32° to 104°F (0° to 40°C) |
| Humidity | 10% to 90% RH (non-condensing) |
| Heat Dissipation | 102 BTU/Hr maximum |
Enclosure |
| Chassis | Metal, matte black finish, convection cooled, vented sides |
| Faceplate | Metal, matte black finish with polycarbonate label overlay |
| Mounting | Freestanding or 3U 19-inch rack-mountable (adhesive feet and rack ears included) |
Dimensions |
| Height | 5.20 in (133 mm) without feet |
| Width | 17.03 in (433 mm); |
19.00 in (483 mm) with ears |
| Depth | 13.13 in (334 mm) |
Weight |
| 14.5 lb (6.58 kg) |